Juniper JUNOS OS 10.3 - SYSTEM LOG MESSAGES REFERENCE 7-12-2010 Reference Manual page 577

Type
Severity
Facility
RPD_ISIS_ADJUPNOIP
System Log Message
Description
Type
Severity
Facility
Cause
Action
RPD_ISIS_LDP_SYNC
System Log Message
Description
Type
Severity
Facility
Action
RPD_ISIS_LSPCKSUM
System Log Message
Description
Type
Severity
Facility
Copyright © 2010, Juniper Networks, Inc.
Event: This message reports an event, not an error
info
LOG_DAEMON
IS-IS new Lisis-level adjacency to neighbor-system-ids on interface-name without an
address
An IS-IS adjacency was established with the indicated neighboring router, which is not
configured for IS-IS for IP.
Event: This message reports an event, not an error
notice
LOG_DAEMON
The neighboring router is misconfigured: it is enabled for IS-IS but not for exchange of IP
route information.
Configure the neighboring router for IS-IS with IP, or remove it from the IS-IS mesh.
IS-IS interface interface-name advertised with infinite metric for duration seconds already
due to loss of synchronization with LDP
The IS-IS protocol lost synchronization with the Label Distribution Protocol (LDP) on the
indicated interface. As a consequence, it began advertising an infinite metric for the
interface and has been doing so for the indicated number of seconds.
Error: An error occurred
warning
LOG_DAEMON
Determine why LDP lost synchronization with IS-IS.
IS-IS Lisis-level LSP checksum error, interface interface-name, LSP id lspl, sequence
sequence-number, checksum checksum, lifetime duration
The indicated IS-IS informational link-state PDU (LSP) failed an internal checksum
validity test, implying that it was corrupted.
Error: An error occurred
warning
LOG_DAEMON
Chapter 73: RPD System Log Messages
513