Delete A Local User - Digi LR54 User Manual

User authentication
where value is any number of weeks, days, hours, minutes, or seconds, and takes the
format number{w|d|h|m|s}.
For example, to set login_limit_period to ten minutes, enter either 10m or 600s:
(config auth user name 2fa)> login_limit_period 600s
(config auth user name 2fa)>
The default is 30s.
j. Scratch codes are emergency codes that may be used once, at any time. To add a scratch
code:
i. Change to the user's scratch code node:
(config auth user new_user 2fa)> scratch_code
(config auth user new_user 2fa scratch_code)>
ii. Add a scratch code:
(config auth user new_user 2fa scratch_code)> add end code
(config auth user new_user 2fa scratch_code)>
Where code is an digit number, with a minimum of 10000000.
iii. To add additional scratch codes, use the add end code command again.
10. Save the configuration and apply the change:
(config auth user new 2fa scratch_code)> save
Configuration saved.
>
11. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Delete a local user

To delete a user from your LR54:

Web
1. Log into Digi Remote Manager, or log into the local Web UI as a user with full Admin access
rights.
2. Access the device configuration:
Remote Manager:
a. Locate your device as described in
device.
b. Click the Device ID.
c. Click Settings.
d. Click to expand Config.
LR54 User Guide
Use Digi Remote Manager to view and manage your
Local users
805