Table of Contents
Advertisement
User authentication
i. Change to the user's scratch code node:
(config auth user new_user 2fa)> scratch_code
(config auth user new_user 2fa scratch_code)>
ii. Add a scratch code:
(config auth user new_user 2fa scratch_code)> add end code
(config auth user new_user 2fa scratch_code)>
Where code is an digit number, with a minimum of 10000000.
iii. To add additional scratch codes, use the add end code command again.
9. Save the configuration and apply the change:
(config auth user new 2fa scratch_code)> save
Configuration saved.
>
10. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Delete a local user
To delete a user from your IX20:
WebUI
1. Log into the IX20 WebUI as a user with full Admin access rights.
2. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click Authentication > Users.
IX20 User Guide
Local users
605
Advertisement
Table of Contents
