Table of Contents
Advertisement
Services
Configure telnet access
By default, the telnet service is disabled.
Note
Telnet is an insecure protocol and should only be used for backward-compatibility reasons, and
only if the network connection is otherwise secured.
Required configuration items
Enable telnet access.
n
Configure access control for the telnet service.
n
Additional configuration items
Port to use for communications with the telnet service.
n
Multicast DNS (mDNS) support.
n
See
Set the idle timeout for IX20 users
telnet service.
Enable the telnet service
The telnet service is disabled by default. To enable the service:
WebUI
1. Log into the IX20 WebUI as a user with full Admin access rights.
2. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click Services > telnet.
4. Click Enable.
IX20 User Guide
for information about setting the inactivity timeout for the
Configure telnet access
427
Advertisement
Table of Contents
