Configure An Openvpn Client Without Using An .Ovpn File - Digi IX30 User Manual

Virtual Private Networks (VPN)
8. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
9. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Configure an OpenVPN client without using an .ovpn file

Required configuration items
Enable the OpenVPN client.
n
The OpenVPN client is enabled by default.
The mode used by the OpenVPN server, either routing (TUN), or bridging (TAP).
n
The firewall zone to be used by the OpenVPN client.
n
The IP address of the OpenVPN server.
n
Certificates and keys:
n
The CA certificate (usually in a ca.crt file).
l
The Public key (for example, client.crt)
l
The Private key (for example, client.key).
l
Additional configuration items
The route metric for the OpenVPN client.
n
The login credentials for the OpenVPN client, if configured on the OpenVPN server.
n
Additional OpenVPN parameters.
n
See Configure SureLink active recovery for OpenVPN

Web
1. Log into Digi Remote Manager, or log into the local Web UI as a user with full Admin access
rights.
2. Access the device configuration:
Remote Manager:
a. Locate your device as described in
device.
b. Click the Device ID.
c. Click Settings.
d. Click to expand Config.
Local Web UI:
IX30 User Guide
for information about OpenVPN active recovery.
Use Digi Remote Manager to view and manage your
OpenVPN
410