Configure A Wi-Fi Access Point With Personal Security - Digi TX54 User Manual

Wi-Fi
broadcast traffic on the wireless network until the Wi-Fi radio is restarted. The default is 10
minutes.
1. Assign the Wi-Fi access point to a LAN interface or to a bridge. See
Configure a bridge
The access point must be assigned to an active LAN, or a bridge that is assigned to an active
LAN.
2. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
3. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Configure a Wi-Fi access point with personal security

The WPA and WPA2 personal security modes allow a Wi-Fi access point to authenticate clients by
using a preshared key that the client enters when connecting to the access point.
By default, the TX54 device comes with either one or two preconfigured access points:
Single-Wi-Fi models: Digi AP (Wi-Fi).
n
Dual-Wi-Fi models: Digi AP (Wi-Fi) and Digi AP (Wi-Fi2).
n
You cannot delete default access points, but you can modify them or you can create your own access
points.
Required configuration items
Enable the Wi-Fi access point
n
Select a Wi-Fi radio for the access point.
n
The Service Set Identifier (SSID) for the access point.
n
Configure security for the access point to use personal security.
n
The password (preshared key) that clients will used to connect to the access point.
n
LAN/bridge assignment. Once you configure a Wi-Fi access point, you must assign the Wi-Fi
n
access point to a LAN interface or to a bridge. See
more information.
Additional configuration items
Determine whether to broadcast the access point's SSID.
n
Determine whether to isolate clients connected to this access point, so that they cannot
n
communicate with each other.
The amount of time to wait before changing the group key.
n
To configure a Wi-Fi access point to use personal security:

WebUI
TX54 User Guide
Configure a Wi-Fi access point with personal security
for more information.
Configure a LAN
Configure a LAN and Configure a bridge
and
for
231