Configure A Wi-Fi Access Point With Personal Security - Digi IX20-WAG4 User Manual

Wi-Fi
(config)> network wifi ap digi_ap isolate_client true
(config)>
See Isolate Wi-Fi clients
access points from communicating with each other.
8. (Optional) Set the amount of time to wait before changing the group key.
The group key is shared by all in clients of the access point, and after a client has
disconnected, it will be able to use the group key to decrypt broadcast packets until the key is
changed.
(config)> network wifi ap digi_ap encryption group_rekey value
(config)>
where value is any number of days, hours, minutes, or seconds, and takes the format number
{d|h|m|s}.
For example, to set group rekey interval to ten minutes, enter either 10m or 600s:
(config)> network wireless ap digi_ap encryption group_rekey 600s
(config)>
Increasing the time between rekeys can improve connectivity issues in noisy environments. To
disable group rekeys, set to 0. This will allow any client that has previously connected to see
all broadcast traffic on the wireless network until the Wi-Fi radio is restarted. The default is 10
minutes.
1. Assign the Wi-Fi access point to a LAN interface or to a bridge. See
Configure a bridge
The access point must be assigned to an active LAN, or a bridge that is assigned to an active
LAN.
2. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
3. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Configure a Wi-Fi access point with personal security

The WPA and WPA2 personal security modes allow a Wi-Fi access point to authenticate clients by
using a preshared key that the client enters when connecting to the access point.
By default, the IX20W device comes with one preconfigured access point, Digi AP. You cannot delete
default access points, but you can modify them or you can create your own access points.
Note The IX20W device supports a maximum of two enabled access points, regardless of the number
of enabled Wi-Fi clients.
IX20 User Guide
Configure a Wi-Fi access point with personal security
for information about how to prevent clients connected to different
for more information.
Configure a LAN and
199