Example: Configure Two Lans - Digi Connect EZ 4 User Manual

Interfaces
a. Add a MAC address to the allowlist:
(config network interface my_lan)> add mac_allowlist end mac_address
(config network interface my_lan)>
where mac_address is a hyphen-separated MAC address, for example, 32-A6-84-2E-81-58.
b. Repeat for each additional MAC address.
11. Save the configuration and apply the change:
(config network interface my_lan)> save
Configuration saved.
>
12. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Example: Configure two LANs

The default configuration of the Connect EZ consists of one WAN (named ETH1), one WWAN (Modem),
and one LAN (ETH2). For Connect EZW Wi-Fi enabled devices, the default configuration of the ETH2
uses a bridge that consists of two devices, the ETH2 Ethernet device and the Digi AP Wi-Fi access
point.
In this example, we will:
1. Create a new Wi-Fi access point (Connect EZW models only).
2. Create a new bridge that consists of the new access point and the ETH1 device.
In this configuration, the ETH1 device will no longer be part of a WAN. Internet access will be
provided by the cellular modem.
3. Create two new LANs:
LAN1 will be configured to use the new bridge.
n
LAN2 will be configured to use the ETH2 device.
n
Task one: Create a new access point (Connect EZW models only)

WebUI
1. Log into the Connect EZ WebUI as a user with full Admin access rights.
2. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click Network > Wi-Fi > Access points.
4. For Add Wi-Fi access point, type Example_AP for the name of the new access point and click
.
Digi Connect EZ 4/4i User Guide
Local Area Networks (LANs)
136