Clear Port-Security - ADTRAN 1000R Series Command Reference Manual

Command Reference Guide

clear port-security

Use the clear port-security command to clear the dynamic or sticky secure media access control (MAC)
addresses associated with an interface. This can be done on a per-address or per-port basis. Variations of
this command include the following:
clear port-security dynamic address <address>
clear port-security dynamic interface <interface id>
clear port-security sticky address <address>
clear port-security sticky interface <interface id>
Syntax Description
dynamic
sticky
address <address>
interface <interface id> Clears the information for the specified interface. Type clear port-security sticky
Default Values
No default value necessary for this command.
Applicable Platforms
This command applies to the NetVanta 300, 1000, and 1000R Series units.
Command History
Release 8.1
Usage Examples
The following command clears all dynamic secure MAC addresses associated with the Ethernet interface
0/1:
>enable
#clear port-security dynamic interface eth 0/1
61200510L1-35E
Clears the dynamic MAC addresses.
Clears the sticky secure MAC addresses.
Clears the information for the specified address.
interface ? or clear port-security dynamic interface ? for a complete list of
applicable interfaces.
Command was introduced.
Copyright © 2005 ADTRAN
Enable Mode Command Set
69