ADTRAN 1000R Series Command Reference Manual page 514

Command Reference Guide
sntp server <address or hostname> version <1-3>
Use the sntp server command to set the hostname of the SNTP server as well as the version of SNTP to
use. The Simple Network Time Protocol (SNTP) is an abbreviated version of the Network Time Protocol
(NTP). SNTP is used to set the time of the AOS product over a network. The SNTP server usually serves
the time to many devices within a network.
Syntax Description
<address or hostname> Specifies the IP address or hostname of the SNTP server.
version <1-3>
Default Values
By default, NTP version is set to 1.
Applicable Platforms
This command applies to the NetVanta 300, 1000, 1000R, 2000, 3000, 4000, and 5000 and
Total Access 900 Series units.
Command History
Release 3.1
Usage Examples
The following example sets the SNTP server to time.nist.gov using SNTP version 1 (the default version):
(config)#sntp server time.nist.gov
The following example sets the SNTP server as time.nist.gov. All requests for time use version 2 of the
SNTP:
(config)#sntp server time.nist.gov version 2
61200510L1-35E
Specifies which NTP version is used (1 to 3).
Command was introduced.
Copyright © 2005 ADTRAN
Global Configuration Mode Command Set
514