ADTRAN 1000R Series Command Reference Manual page 779

Command Reference Guide
spanning-tree link-type [auto | point-to-point | shared]
Use the spanning-tree link-type command to configure the spanning-tree protocol link type for an
interface. To return to the default value, use the no form of this command.
Syntax Description
auto
point-to-point
shared
Default Values
By default, a port is set to auto.
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 3000, and 4000 Series units.
Command History
Release 5.1
Release 8.1
Functional Notes
This command overrides the default link-type setting determined by the duplex of the individual port. By
default a port configured for half-duplex is set to shared link type, and a port configured for full-duplex is
set to point-to-point link type. Setting the link type manually overrides the default and forces the port to
use the specified link type. Using the link-type auto command, restores the convention of determining link
type based on duplex settings.
Usage Examples
The following example forces the link-type to point-to-point, even if the port is configured to be half-duplex:
(config)#bridge 1 protocol ieee
(config)#interface atm 1.1
(config-atm 1.1)#spanning-tree link-type point-to-point
Technology Review
Rapid transitions are possible in rapid spanning-tree protocol (RSTP) by taking advantage of point-to-point
links (a port is connected to exactly one other bridge) and edge-port connections (a port is not connected
to any additional bridges). Setting the link type to auto allows the spanning tree to automatically configure
the link type based on the duplex of the link. Setting the link type to point-to-point allows a half-duplex link
to act as if it were a point-to-point link.
61200510L1-35E
Determines link type by the port's duplex settings.
Manually sets link type to point-to-point, regardless of duplex settings.
Manually sets link type to shared, regardless of duplex settings.
Command was introduced.
ATM sub-interface was added.
Copyright © 2005 ADTRAN
ATM Sub-Interface Config Command Set
779