Snmp Trap - ADTRAN 1000R Series Command Reference Manual

Command Reference Guide

snmp trap

Use the snmp trap command to enable all supported Simple Network Management Protocol (SNMP)
traps on the interface.
Syntax Description
No subcommands.
Default Values
By default, all interfaces (except virtual Frame Relay interfaces and sub-interfaces) have SNMP traps
enabled.
Applicable Platforms
This command applies to the NetVanta 1000R, 3000, and 4000 Series units.
Command History
Release 1.1
Release 3.1
Release 5.1
Usage Examples
The following example enables SNMP capability on the DDS interface:
(config)#interface dds 1/1
(config-dds 1/1)#snmp trap
61200510L1-35E
Command was introduced.
Command was extended to the SHDSL interface.
Command was expanded to include Ethernet sub-interfaces and Gigabit Ethernet
interfaces.
Copyright © 2005 ADTRAN
DDS Interface Configuration Command Set
584