ADTRAN 1000R Series Command Reference Manual page 294

Command Reference Guide
show spanning-tree interface port-channel <interface id> [active |
active detail | cost | detail | detail active | edgeport | priority |
rootcost | state]
Use the show spanning-tree interface port-channel command to display spanning-tree protocol
information for a particular port channel interface.
Syntax Description
<slot/port>
active
active detail
cost
detail
detail active
edgeport
priority
rootcost
state
Default Values
No default value necessary for this command.
Applicable Platforms
This command applies to the NetVanta 300, 1000, and 1000R Series units.
Command History
Release 5.1
Usage Examples
The following is an example output using the show spanning-tree interface port-channel command:
>enable
#show spanning-tree interface port-channel 1
Interface Role
------------------- ------------------- ------------------
p-chan 1 Desg
61200510L1-35E
Specifies the slot and port number of the interface.
Optional. Displays information for an active interface.
Optional. Displays detailed spanning-tree protocol information for an active
interface.
Optional. Displays only spanning-tree protocol path cost information.
Optional. Displays detailed spanning-tree protocol information.
Optional. Displays detailed spanning-tree protocol information for an active
interface.
Optional. Displays information for all interfaces configured as edgeports.
Optional. Displays only spanning-tree protocol priority information.
Optional. Displays only spanning-tree protocol root path cost information.
Optional. Displays only spanning-tree protocol state information.
Command was introduced.
Sts
FWD
Copyright © 2005 ADTRAN
Cost Prio.Nbr
----------- -------------
19 128.27
Enable Mode Command Set
Type
---------------
P2p
294