ADTRAN 1000R Series Command Reference Manual page 672

Command Reference Guide
caller-id override [always <number> | if-no-cid <number>]
Use the caller-id override command to configure the unit to replace caller ID information with a
user-specified number. Use the no form of this command to disable any caller ID overrides.
Syntax Description
always <number>
if-no-cid <number>
Default Values
By default, this command is disabled.
Applicable Platforms
This command applies to the NetVanta 1000R, 3000, and 4000 Series units.
Command History
Release 6.1
Functional Notes
This command forces a replacement of the incoming caller ID number with the number given. The received
caller ID, if any, is discarded, and the given override number is used to connect the incoming call to a
circuit of the same number.
Usage Examples
The following example configures the unit to always provide the given number as the caller ID number:
(config)#interface modem 1/2
(config-modem 1/2)#caller-id override always 5555555
61200510L1-35E
Always forces replacement of the incoming caller ID number with the number
given.
Replaces the incoming caller ID number with the number given only if there is no
caller ID information available for the incoming call.
Command was introduced.
Copyright © 2005 ADTRAN
Modem Interface Configuration Command Set
672