Table of Contents
Advertisement
Command Reference Guide
SHDSL I
NTERFACE
To activate the SHDSL Interface Configuration mode, enter the interface shdsl command at the Global
Configuration mode prompt. For example:
>enable
#configure terminal
(config#)interface shdsl 1/1
(config-shdsl 1/1)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
alias <"text">
on page 27
cross-connect <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port>
on page 28
description <text>
do
on page 32
end
on page 33
exit
on page 34
shutdown
on page 35
All other commands for this command set are described in this section in alphabetical order.
alarm-threshold [loop-attenuation | snr-margin] <value>
boot alternate-image
equipment-type [co | cpe]
inband-detection
on page 689
inband-protocol [pn127 | v54]
linerate <value>
on page 691
loopback network
on page 692
loopback remote
on page 693
loopback remote inband
outage-retrain
on page 695
test-pattern [clear | insert | 2^15 | show]
61200510L1-35E
C
ONFIGURATION
on page 31
on page 687
on page 688
on page 690
on page 694
on page 696
Copyright © 2005 ADTRAN
SHDSL Interface Configuration Command Set
C
S
OMMAND
on page 686
ET
685
Hide quick links:
Advertisement
Chapters
Table of Contents
