ADTRAN 1000R Series Command Reference Manual page 215

Command Reference Guide
show ip bgp <network ip> [</length> | <network-mask>]
Use the show ip bgp <network ip> command to display details about the specified route, including the
advertising router IP address, router ID, and the list of neighbors to which this route is being advertised.
Syntax Description
<network ip>
</length>
<network-mask>
Default Values
No default value necessary for this command.
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 2000, 3000, 4000, and 5000 and
Total Access 900 Series units.
Command History
Release 8.1
Usage Examples
The following example shows detailed output of this command:
>enable
#show ip bgp 10.15.240.0/28
BGP routing table entry for 10.15.240.0/28
Paths: (1 available, best #1)
Advertised to peers:
1.1.5.10
100 1
10.15.43.17 from 10.15.43.17 (8.1.1.1)
Origin IGP, metric 2, valid, external, best
61200510L1-35E
Shows only routes for the specified network.
Optional. Shows only routes for the specified network matching the prefix length
(e.g., /24).
Optional. Shows only routes for the specified network matching the network mask
(e.g., 255.255.255.0).
Command was introduced.
Copyright © 2005 ADTRAN
Enable Mode Command Set
215