Command Reference Guide
qos dscp-cos [<dscp-list> to <cos-priority-list> | default]
Use the qos dscp-cos command to set the Differentiated Services Codepoint (DSCP) to Class of Service
(CoS) map and enable the mapping process. Use the no form of this command to disable mapping.
Syntax Description
<dscp-list>
<cos-priority-list>
default
Default Values
By default, this command is disabled.
Applicable Platforms
This command applies to the NetVanta 300, 1000, and 1000R Series units.
Command History
Release 7.1
Functional Notes
When one of the specified DSCP values is detected in an incoming packet, the CoS priority is altered
based on the corresponding map value. By configuring the list, the mapping functionality is enabled.
Usage Examples
The following example enables the mapping of DSCP values 24 and 48 to CoS values 1 and 2:
(config)#qos dscp-cos 24 48 to 1 2
The following example disables DSCP-to-CoS mapping:
(config)#no qos dscp-cos
61200510L1-35E
Specifies DSCP values (separating multiple values with a space).
Specifies CoS values (separating multiple values with a space).
Sets the map to the following default values:
DSCP
| 0 | 16 | 24 | 32 | 40 | 48 | 56
CoS
| 1 | 2 | 3 | 4 | 5 | 6 | 7
Command was introduced.
Copyright © 2005 ADTRAN
Global Configuration Mode Command Set
487