ADTRAN 1000R Series Command Reference Manual page 688

Command Reference Guide
equipment-type [co | cpe]
Use the equipment-type command to determine the operating mode for the SHDSL interface.
Syntax Description
co
cpe
Default Values
The default for this command is cpe.
Applicable Platforms
This command applies to the NetVanta 1000R, 3000, and 4000 Series units.
Command History
Release 3.1
Usage Examples
The following example changes the operating mode of the SHDSL interface to CO:
(config)#interface shdsl 1/1
(config-shdsl 1/1)#equipment-type co
61200510L1-35E
Use this option only in a campus environment when operating two SHDSL
network interface modules (NIMs) back-to-back. In this setup, configure the
master NIM to CO and the slave NIM to CPE.
Use this option when interfacing directly with your service provider or when acting
as the slave NIM in a campus environment.
Command was introduced.
Copyright © 2005 ADTRAN
SHDSL Interface Configuration Command Set
688