ADTRAN 1000R Series Command Reference Manual page 151

Command Reference Guide Enable Mode Command Set
events
Use the events command to enable event reporting to the current command line interface (CLI) session.
Use the no form of this command to disable all event reporting to the current CLI session.
Syntax Description
No subcommands.
Default Values
By default, this command is enabled.
Applicable Platforms
This command applies to the NetVanta 300, 1000, 1000R, 2000, 3000, 4000, and 5000 and
Total Access 900 Series units.
Command History
Release 3.1 Command was introduced.
Usage Examples
The following example enables event reporting:
>enable
#events
61200510L1-35E Copyright © 2005 ADTRAN 151