Loopback Remote - ADTRAN 1000R Series Command Reference Manual

Command Reference Guide SHDSL Interface Configuration Command Set

loopback remote

Use the loopback remote command to send a loopback request to the remote unit. This command is
functional only in CO operating mode (see the section equipment-type [co | cpe] on page 688). Use the no
form of this command to send a loopdown code to the remote unit to deactivate the loopback.
Syntax Description
No subcommands.
Default Values
No defaults necessary for this command.
Applicable Platforms
This command applies to the NetVanta 1000R, 3000, and 4000 Series units.
Command History
Release 3.1 Command was introduced.
Usage Examples
The following example initiates a remote line loopback:
(config)#interface shdsl 1/1
(config-shdsl 1/1)#loopback remote
61200510L1-35E Copyright © 2005 ADTRAN 693