Debug Dialup-Interfaces - ADTRAN 1000R Series Command Reference Manual

Command Reference Guide Enable Mode Command Set

debug dialup-interfaces

Use the debug dialup-interfaces command to generate debug messages used to aid in troubleshooting
problems with all dialup interfaces such as the modem or the BRI cards. Debug messages are displayed
(real time) on the terminal (or Telnet) screen. Use the no form of this command to disable the debug
messages.
Syntax Description
No subcommands.
Default Values
By default, all debug messages in the AOS are disabled.
Applicable Platforms
This command applies to the NetVanta 1000R, 3000, 4000, and 5000 Series units.
Command History
Release 2.1 Command was introduced.
Functional Notes
When enabled, these messages provide status information on incoming calls, dialing and answering
progress, etc. These messages also give information on why certain calls are dropped or rejected. It is
beneficial to use this command when troubleshooting dial backup (in addition to the debug dial-backup
command).
Usage Examples
The following example activates the debug messages for dialup interfaces:
>enable
#debug dialup-interfaces
61200510L1-35E Copyright © 2005 ADTRAN 105