ADTRAN 1000R Series Command Reference Manual page 222

Command Reference Guide
show ip igmp groups <group-address>
Use the show ip igmp groups command to display the multicast groups that have been registered by
directly connected receivers using Internet Group Management Protocol (IGMP). If no group address is
specified, all groups are shown with this command.
Syntax Description
<group-address>
Default Values
No default value necessary for this command.
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 3000, 4000, and 5000 and Total Access 900 Series
units.
Command History
Release 7.1
Usage Examples
The following is sample output from this command:
>enable
#show ip igmp groups
IGMP Connected Group Membership
Group Address Interface
172.0.1.50 Loopback100
172.1.1.1 Ethernet0/1
172.1.1.1 Loopback100
61200510L1-35E
Optional. Displays the IP address of a multicast group.
Command was introduced.
Uptime
00:42:57
00:05:26
00:42:57
Copyright © 2005 ADTRAN
Expires Last Reporter
00:02:50 172.23.23.1
00:02:51 1.1.1.2
00:02:51 172.23.23.1
Enable Mode Command Set
222