ADTRAN 1000R Series Command Reference Manual page 654

Command Reference Guide
switchport port-security aging [static | time <time> | type absolute]
Use the switchport port-security aging command to enable and configure secure MAC address aging on
a particular interface.
Syntax Description
static
time <time>
type absolute
Default Values
By default, dynamic and static aging are disabled.
Applicable Platforms
This command applies to the NetVanta 300, 1000, and 1000R Series units.
Command History
Release 8.1
Usage Examples
The following example sets the aging time of secure MAC addresses to 10 minutes:
(config)#interface eth 0/1
(config-eth 0/1)#switchport port-security aging time 10
61200510L1-35E
Configures the interface to age static as well as dynamic entries in the secure
MAC address table.
Enables port security aging for dynamic entries in the secure MAC address table
by configuring a time (in minutes). Disable aging by setting the time to 0.
Configures the address to be removed after the specified time, regardless of
activity.
Command was introduced.
Copyright © 2005 ADTRAN
Ethernet Interface Configuration Command Set
654