Interface <Interface> [<Slot/Port> | <Interface Id>] [Point-To-Point - ADTRAN 1000R Series Command Reference Manual

Command Reference Guide
interface <interface> [<slot/port> | <interface id>] [point-to-point]
Use the interface command to activate the interface command set for the specified physical or virtual
interface. Use the no form of this command to delete a configured interface. To activate the interface, enter
the no shutdown command from within the specific interface command set. For example,
(config-ppp 7)#no shutdown.
Syntax Description
<interface>
<slot/port>
<interface id>
point-to-point
Default Values
No default values required for this command.
Applicable Platforms
This command applies to the NetVanta 300, 1000, 1000R, 2000, 3000, 4000, and 5000 and
Total Access 900 Series units.
Command History
Release 1.1
Release 3.1
Release 8.1
Release 9.1
Release 11.1
Usage Examples
The following example enters the serial interface mode for a serial module installed in slot 1:
(config)#interface serial 1/1
(config-ser 1/1)#
61200510L1-35E
Identifies the physical port type of the installed Network Interface Module (NIM),
Dial-Backup Interface Module (DIM), or Ethernet port. Type interface ? for a
complete list of valid interfaces.
Specifies an interface based on its physical location (slot and port). For example,
if you have a T1/DSX-1 NIM installed in Slot 1 of an AOS product:
• The WAN-T1 port would be specified in the CLI as t1 1/1.
• The DSX-1 port would be specified as t1 1/2.
• If (for example) a BRI DIM backup module is also installed, then the DBU port
of the NIM card would be specified as bri 1/3.
• If you are specifying a port that is built into the base unit (e.g., the Ethernet
port), the slot number is 0. For example, the Ethernet (LAN) port would be
specified as eth 0/1.
Specifies the numerical interface ID using a numerical string. Valid range is 1 to
1024. To specify a sub-interface the following syntax applies:
interface atm <interface id>.<sub-interface id>. Valid range is 1 to 255.
Optional. Identifies the interface as a point-to-point link (versus multilink). Valid
only on interfaces that support point-to-point (e.g., ATM and Frame Relay). By
default, all created ATM and Frame Relay interfaces are point-to-point.
Command was introduced.
Command expanded to include loopback interface.
Command expanded to include ATM interface.
Command expanded to include HDLC interface.
Command expanded to include demand, FXO, and PRI interfaces.
Copyright © 2005 ADTRAN
Global Configuration Mode Command Set
390