ADTRAN 1000R Series Command Reference Manual page 570

Command Reference Guide
bonding txfa-timer <seconds>
Use the bonding txfa-timer command to specify the value (in seconds) for the frame pattern detection
timeout. Use the no form of this command to return to the default value.
Syntax Description
<seconds>
Default Values
By default, the bonding txfa-timer value is 10 seconds.
Applicable Platforms
This command applies to the NetVanta 1000R, 3000, and 4000 Series units.
Command History
Release 1.1
Functional Notes
Specifies the length of time both endpoints attempt to detect the bonding frame pattern when a call is
connected before deciding the bonding call has failed. When operating with other manufacturers' bonding
equipment, it may be necessary to change this time so that it matches TXADD01.
Usage Examples
The following example defines a bonding txfa-timer value of 15 seconds:
(config)#interface bri 1/2
(config-bri 1/2)#bonding txfa-timer 15
61200510L1-35E
Specifies the number of seconds the endpoint allots for attempting to detect the
bonding frame pattern (when a call is connected) before considering the bonding
negotiation a failure.
Command was introduced.
Copyright © 2005 ADTRAN
BRI Interface Configuration Command set
570