Command Reference Guide
L
(C
INE
ONSOLE
To activate the Line (Console) Interface Configuration mode, enter the line console 0 command at the
Global Configuration mode prompt. For example:
>enable
#configure terminal
(config)#line console 0
(config-con 0)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
cross-connect <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port>
on page 28
do
on page 32
end
on page 33
exit
on page 34
All other commands for this command set are described in this section in alphabetical order.
accounting commands [<level> l <name> l default]
authorization commands [<level> l <name> l default]
databits [7 | 8]
on page 535
flowcontrol [none | software in]
line-timeout <minutes>
login
on page 538
login authentication <aaa login list>
login local-userlist
parity [even | mark | none | odd | space]
password [md5] <password>
speed <rate>
on page 543
stopbits [1 | 2]
on page 544
61200510L1-35E
) I
NTERFACE
on page 536
on page 537
on page 539
on page 540
on page 541
on page 542
Copyright © 2005 ADTRAN
Line (Console) Interface Config Command Set
C
C
ONFIG
OMMAND
on page 533
on page 534
S
ET
532