ADTRAN 1000R Series Command Reference Manual page 690

Command Reference Guide
inband-protocol [pn127 | v54]
Use the inband-protocol command to designate the inband loopback pattern to send/detect on the SHDSL
interface. Use the no form of this command to return to default.
Syntax Description
pn127
v54
Default Values
By default, the inband-protocol is set to v54.
Applicable Platforms
This command applies to the NetVanta 1000R, 3000, and 4000 Series units.
Command History
Release 4.1
Functional Notes
Inband loopbacks are specific patterns that are sent in place of user data to trigger a loopback. Both
PN127 and V.54 are industry-standard loopback patterns used to allow remote loopbacks.
Usage Examples
The following example sets the inband loopback pattern for PN127:
(config)#interface shdsl 1/1
(config-shdsl 1/1)#inband-protocol pn127
61200510L1-35E
Selects PN127 as the inband loopback pattern to send/detect.
Selects V.54 as the inband loopback pattern to send/detect.
Command was introduced.
Copyright © 2005 ADTRAN
SHDSL Interface Configuration Command Set
690