ADTRAN 1000R Series Command Reference Manual page 643

Command Reference Guide
spanning-tree pathcost method [short | long]
Use the spanning-tree pathcost command to select a short or long method used by the spanning-tree
protocol.
Syntax Description
short
long
Default Values
By default, spanning-tree pathcost is set to short.
Applicable Platforms
This command applies to the NetVanta 1000, 1000R, 3000, 4000, and 5000 Series units.
Command History
Release 5.1
Usage Examples
The following example specifies that the spanning tree protocol use a long pathcost method:
(config)#spanning-tree pathcost method long
61200510L1-35E
Specifies 16-bit values when calculating pathcosts.
Specifies 32-bit values when calculating pathcosts.
Command was introduced.
Copyright © 2005 ADTRAN
Ethernet Interface Configuration Command Set
643