Atm Sub-Interface Config Command Set - ADTRAN 1000R Series Command Reference Manual

Command Reference Guide
ATM S -I
UB NTERFACE
To activate the ATM Interface Configuration mode, enter the interface atm command (and specify a
sub-interface) at the Global Configuration mode prompt. For example:
>enable
#configure terminal
(config)#interface atm 1.1
(config-atm 1.1)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
cross-connect <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port>
on page 28
description <text>
do on page 32
end on page 33
exit on page 34
shutdown on page 35
All other commands for this command set are described in this section in alphabetical order.
access-policy <policyname>
bandwidth <value>
bridge-group <group#>
crypto map <mapname>
dial-backup commands
dynamic-dns [dyndns | dyndns-custom | dyndns-static] <hostname> <username>
<password> on page 742
encapsulation [aal5mux | aal5snap]
fair-queue <threshold>
hold-queue <queue size> out
ip commands begin on
max-reserved-bandwidth <percent>
mtu <size> on page 770
oam retry <up-count> <down-count> <retry-frequency>
oam-pvc managed <frequency>
pvc <VPI/VCI> on page 773
qos-policy out <mapname>
spanning-tree commands
61200510L1-35E
C
ONFIG
on page 31
on page 718
on page 722
on page 723
on page 724
begin on page 726
on page 744
on page 745
on page 746
page 747
on page 769
on page 772
on page 774
begin on page 776
Copyright © 2005 ADTRAN

ATM Sub-Interface Config Command Set

C S
OMMAND ET
on page 771
717