Hdlc Command Set - ADTRAN 1000R Series Command Reference Manual

Command Reference Guide
HDLC C
OMMAND
To activate the HDLC mode, enter the interface hdcl command at the Global Configuration mode prompt.
For example:
>enable
#configure terminal
(config)#interface hdlc 1
(config-hdlc 1)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
alias <"text"> on page 27
cross-connect <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port>
on page 28
description <text>
do on page 32
end on page 33
exit on page 34
shutdown on page 35
All other commands for this command set are described in this section in alphabetical order.
access-policy <policyname>
alias link<"text">
bandwidth <value>
bridge-group <group#>
crypto map <mapname>
dial-backup commands
dynamic-dns [dyndns | dyndns-custom | dyndns-static] <hostname> <username>
<password> on page 952
fair-queue <threshold>
hold-queue <queue size> out
ip commands begin on
keepalive <seconds>
lldp receive on page 975
lldp send [management-address l port-description l system-capabilities l system-description l
system-name l and-receive]
61200510L1-35E
S
ET
on page 31
on page 928
on page 931
on page 932
on page 933
on page 934
on page 936
on page 954
on page 955
page 956
on page 974
on page 976
Copyright © 2005 ADTRAN

HDLC Command Set

926