Show Spanning-Tree Pathcost Method - ADTRAN 1000R Series Command Reference Manual

Command Reference Guide Enable Mode Command Set

show spanning-tree pathcost method

Use the show spanning-tree pathcost method command to display the default pathcost method being
used.
Syntax Description
No subcommands.
Default Values
No default value necessary for this command.
Applicable Platforms
This command applies to the NetVanta 300, 1000, and 1000R Series units.
Command History
Release 5.1 Command was introduced.
Usage Examples
The following is sample output using the show spanning-tree pathcost method command. In this case
32-bit values are being used when calculating path costs:
>enable
#show spanning-tree pathcost method
Spanning tree default pathcost method used is long
61200510L1-35E Copyright © 2005 ADTRAN 295