ADTRAN 1000R Series Command Reference Manual page 96

Command Reference Guide
debug atm oam <vcd> loopback [end-to-end | segment] <LLID>
Use the debug atm oam command to display Operation, Administration, and Maintenance (OAM) packets
for an ATM virtual circuit descriptor (VCD). Debug messages are displayed (real time) to the terminal (or
Telnet) screen. Use the no form of this command to disable debug messages.
Variations of this command include the following:
debug atm oam <vcd>
debug atm oam <vcd> loopback [end-to-end | segment]
debug atm oam <vcd> loopback [end-to-end | segment] <LLID>
Syntax Description
<vcd>
loopback
end-to-end
segment
<LLID>
Default Values
By default, all debug messages in the AOS are disabled.
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 3000, and 4000 Series units.
Command History
Release 8.1
Usage Examples
The following example activates ATM OAM debug messages for VCD 1:
>enable
#debug atm oam 1
61200510L1-35E
Shows OAM packets for a specific VCD.
Configures an OAM loopback.
Configures an end-to-end OAM loopback.
Configures a segment loopback.
Specifies 16-byte OAM loopback location ID (LLID).
Command was introduced.
Copyright © 2005 ADTRAN
Enable Mode Command Set
96