ADTRAN 1000R Series Command Reference Manual page 658

Command Reference Guide
switchport port-security violation [protect l restrict l shutdown]
Use the switchport port-security violation command to configure the action to be taken once a security
violation is encountered. Use the no form of this command to return to the default setting.
Syntax Description
protect
restrict
shutdown
Default Values
The default for this command is shutdown.
Applicable Platforms
This command applies to the NetVanta 300, 1000, and 1000R Series units.
Command History
Release 8.1
Usage Examples
The following example configures the interface to react to security violations by not learning the addresses
of and not accepting data from the violation source:
(config)#interface eth 0/1
(config-eth 0/1)#switchport port-security violation restrict
61200510L1-35E
Determines that the unit will not learn any new secure addresses (nor allow these
new sources to pass traffic) until the number of currently active secure addresses
drops below the maximum setting.
Determines that the security violation counter increments and an SNMP trap is
sent once a violation is detected. The new address is not learned and data from
that address is not allowed to pass.
Determines that the interface is disabled once a violation is detected. A no
shutdown command is required to re-enable the interface.
Command was introduced.
Copyright © 2005 ADTRAN
Ethernet Interface Configuration Command Set
658