Atm Interface Config Command Set - ADTRAN 1000R Series Command Reference Manual

Command Reference Guide
ATM I
NTERFACE
To activate the ATM Interface Configuration mode, enter the interface atm command at the Global
Configuration mode prompt. For example:
>enable
#configure terminal
(config)#interface atm 1
(config-atm 1)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
alias <"text"> on page 27
cross-connect <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port>
on page 28
description <text>
do on page 32
end on page 33
exit on page 34
shutdown on page 35
All other commands for this command set are described in this section in alphabetical order.
snmp trap on page 715
snmp trap link-status
61200510L1-35E
C C
ONFIG OMMAND
on page 31
on page 716
Copyright © 2005 ADTRAN

ATM Interface Config Command Set

S
ET
714