Show Spanning-Tree Blockedports - ADTRAN 1000R Series Command Reference Manual

Command Reference Guide Enable Mode Command Set

show spanning-tree blockedports

Use the show spanning-tree blockedports command to display ports that are currently in a blocked state.
Syntax Description
No subcommands.
Default Values
No default value necessary for this command.
Applicable Platforms
This command applies to the NetVanta 300, 1000, and 1000R Series units.
Command History
Release 5.1 Command was introduced.
Usage Examples
The following is an example output using the show spanning-tree blockedports command:
>enable
#show spanning-tree blockedports
Blocked Interfaces List
------------------------------------
eth 0/3
giga-eth 0/2
p-chan 1
Number of blocked ports (segments) in the system: 3
61200510L1-35E Copyright © 2005 ADTRAN 290