Enable Mode Command Set - ADTRAN 1000R Series Command Reference Manual

Command Reference Guide
E M
NABLE ODE
To activate the Enable mode, enter the enable command at the Basic mode prompt. (If an enable password
has been configured, a password prompt will display.) For example:
>enable
Password: XXXXXXX
#
The following command is common to multiple command sets and is covered in a centralized section of
this guide. For more information, refer to the section listed below:
exit on page 34
All other commands for this command set are described in this section in alphabetical order.
clear commands begin on page 38
clock auto-correct-dst
clock no-auto-correct-dst
clock set <time> <day> <month> <year>
clock timezone <text>
configure [memory | network | overwrite-network | terminal]
copy <source> <destination>
copy console <filename>
copy flash <destination>
copy <filename> interface <interface> <slot/port>
copy tftp <destination>
copy xmodem <destination>
debug commands begin on page 93
dir on page 146
dir [<input> | flash | flash <input>]
disable on page 148
enable on page 149
erase [<filename> | startup-config]
events on page 151
exception report generate
logout on page 153
ping <address> on page 154
ping stack-member
reload [cancel | in <delay>]
61200510L1-35E
C S
OMMAND ET
on page 80
on page 81
on page 83
on page 87
on page 88
on page 89
on page 91
on page 92
on page 147
on page 150
on page 152
on page 156
on page 157
Copyright © 2005 ADTRAN
on page 82
on page 86
on page 90

Enable Mode Command Set

36