ADTRAN 1000R Series Command Reference Manual page 965

Command Reference Guide
ip ospf
Use the ip ospf command to customize OSPF settings (if needed).
Syntax Description
authentication-key
cost <value>
dead-interval <seconds>
hello-interval <seconds>
message-digest-key <keyid> md5 <key>
priority <value>
retransmit-interval <seconds>
transmit-delay <seconds>
Default Values
retransmit-interval <seconds>
transmit-delay <seconds>
hello-interval <seconds>
dead-interval <seconds>
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 3000, 4000, and 5000 and Total Access 900 Series
units.
Command History
Release 9.1
61200510L1-35E
Specifies a simple-text authentication password to be used
by other routers using <password> the OSPF simple
password authentication.
Specifies the OSPF cost of sending a packet on the interface.
This value overrides any computed cost value.
Range: 1 to 65535.
Sets the maximum interval allowed between hello packets. If
the maximum is exceeded, neighboring devices will
determine that the device is down. Range: 0 to 32767.
Specifies the interval between hello packets sent on the
interface. Range: 0 to 32767.
Configures OSPF Message Digest 5 (MD5) authentication
(16-byte max) keys.
Set the OSPF priority. The value set in this field helps
determine the designated router for this network.
Range: 0 to 255.
Specifies the time between link-state advertisements (LSAs).
Range: 0 to 32767.
Sets the estimated time required to send an LSA on the
interface. Range: 0 to 32767.
5 seconds
1 second
10 seconds: Ethernet, point-to-point, Frame Relay, and PPP
40 seconds
Command was introduced.
Copyright © 2005 ADTRAN
HDLC Command Set
965