ADTRAN 1000R Series Command Reference Manual page 735

Command Reference Guide
dial-backup number <digits> [analog | digital-56k | digital 64k]
<isdn min chan> <isdn max chan> <interface>
Use the dial-backup number command to configure the phone number and the call type the router will
dial upon network failure. Multiple entries can be made for a sub-interface to allow alternate sites to be
dialed. For more detailed information on ATM dial-backup functionality, refer to the Functional Notes and
Technology Review sections of the command dial-backup call-mode [answer | answer-always | originate |
originate-answer | originate-answer-always]
Syntax Description
<digits>
analog ppp
digital-56k
digital-64k
<isdn min chan>
<isdn mas chan>
<interface>
Default Values
By default, there are no configured dial-backup numbers.
Applicable Platforms
This command applies to the NetVanta 1000R, 3000, and 4000 Series units.
Command History
Release 1.1
Release 8.1
Usage Examples
The following example configures the AOS to dial 704-555-1212 (digital 64 kbps connection) to initiate
dial-backup operation on this endpoint:
(config)#interface atm 1.1
(config-atm 1.1)#dial-backup number 7045551212 digital-64k 1 1 atm 3.1
61200510L1-35E
on page
Specifies the phone numbers to call when the backup is initiated.
Specifies number connects to an analog modem.
Specifies number belongs to a digital 56 kbps per DS0 connection.
Specifies number belongs to a digital 64 kbps per DS0 connection.
Specifies the minimum number of DS0s required for a digital 56 or 64 kbps
connection (Range: 1 to 24).
Specifies the maximum number of DS0s desired for a digital 56 or 64 kbps
connection (Range: 1 to 24).
Specifies the ATM sub-interface (e.g., ATM 3.1) to use when originating or answering
using this number.
Command was introduced.
ATM sub-interface was added.
Copyright © 2005 ADTRAN
ATM Sub-Interface Config Command Set
729.
735