Table of Contents
Advertisement
Command Reference Guide
Not all Ethernet commands apply to all Ethernet types. Use the ? command to display a list
of valid commands. For example:
>enable
Password:xxxxx
#config term
(config)#int eth 0/1
(config-eth 0/1)#?
access-policy
alias
arp
bandwidth
bridge-group
etc....
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
alias <"text">
on page 27
description <text>
do
on page 32
end
on page 33
exit
on page 34
shutdown
on page 35
All other commands for this command set are described in this section in alphabetical order.
arp arpa
on page 616
bridge-group <group#>
channel-group <group#> mode on
crypto map <mapname>
dynamic-dns [dyndns | dyndns-custom | dyndns-static] <hostname> <username> <password>
page 621
full-duplex
on page 623
half-duplex
on page 625
lldp receive
on page 626
lldp send [management-address l port-description l system-capabilities l system-description l
system-name l and-receive]
61200510L1-35E
- Assign access control policy for this interface
- A text name assigned by an SNMP NMS
- Set ARP commands
- Set bandwidth informational parameter
- Assign the current interface to a bridge group
on page 31
on page 617
on page 618
on page 619
on page 627
Copyright © 2005 ADTRAN
Ethernet Interface Configuration Command Set
on
614
Hide quick links:
Advertisement
Chapters
Table of Contents
