ADTRAN 1000R Series Command Reference Manual page 646

Command Reference Guide
storm-control [broadcast level | multicast level | unicast level]
<rising level> <falling level>]
Use the storm-control command to configure limits on the rates of broadcast, multicast, and unicast traffic
on a port. To disable storm-control, use the no version of this command.
Syntax Description
broadcast level
multicast level
unicast level
<rising level>
<falling level>
Default Values
By default, storm-control is disabled.
Applicable Platforms
This command applies to the NetVanta 300, 1000, and 1000R Series units.
Command History
Release 5.1
Functional Notes
This setting configures the rising and falling suppression values. When the selected rising level (which is a
percentage of total bandwidth) is reached, the port begins blocking packets of the specified type (i.e.,
broadcast, multicast, or unicast). The AOS uses the rising level as its falling level if no falling level is
specified.
61200510L1-35E
Sets levels for broadcast traffic.
Sets levels for multicast traffic.
Sets levels for unicast traffic.
Specifies a rising level which determines the percentage of total bandwidth the
port accepts before it begins blocking packets. Range: 0 to 100 percent.
Optional. Specifies a falling level which determines when the storm is considered
over, causing the AOS to no longer block packets. This level must be less than the
rising level. Range: 0 to 100 percent.
Command was introduced.
Copyright © 2005 ADTRAN
Ethernet Interface Configuration Command Set
646