Modem Interface Configuration Command Set - ADTRAN 1000R Series Command Reference Manual

Command Reference Guide
M I
ODEM NTERFACE
To activate the Modem Interface Configuration mode, enter the interface modem command at the Global
Configuration mode prompt. For example:
>enable
#configure terminal
(config)#interface modem 1/2
(config-modem 1/2)#
The modem interface number in the example above is shown as modem 1/2. This number is
based on the interface's location (slot/port) and could vary depending on the unit's
configuration. Use the do show interfaces command to determine the appropriate
interface number.
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
alias <"text"> on page 27
cross-connect <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port>
on page 28
description <text>
do on page 32
end on page 33
exit on page 34
shutdown on page 35
All other commands for this command set are described in this section in alphabetical order.
caller-id override [always <number> | if-no-cid <number>]
dialin on page 673
init-string <string>
resource pool-member <pool-name> [<cost>]
61200510L1-35E
C
ONFIGURATION
on page 31
on page 674
Copyright © 2005 ADTRAN

Modem Interface Configuration Command Set

C
OMMAND
on page 672
on page 675
S
ET
671