ADTRAN 1000R Series Command Reference Manual page 689

Command Reference Guide SHDSL Interface Configuration Command Set
inband-detection
Use the inband-detection command to enable inband loopback pattern detection on the SHDSL interface.
Use the no form of this command to disable inband-detection.
Syntax Description
No subcommands.
Default Values
By default, this command is enabled.
Applicable Platforms
This command applies to the NetVanta 1000R, 3000, and 4000 Series units.
Command History
Release 4.1 Command was introduced.
Usage Examples
The following example disables inband loopback pattern detection:
(config)#interface shdsl 1/1
(config-shdsl 1/1)#no inband-detection
61200510L1-35E Copyright © 2005 ADTRAN 689