ADTRAN 1000R Series Command Reference Manual page 266

Command Reference Guide
show port-security [address | interface <interface id> | port-expiration]
detailed
Use the show port-security command to display port security information.
Syntax Description
address
interface
port-expiration
detailed
Default Values
No default value necessary for this command.
Applicable Platforms
This command applies to the NetVanta 300, 1000, and 1000R Series units.
Command History
Release 8.1
Usage Examples
The following displays all secure MAC addresses related to the Ethernet 0/1 interface:
>enable
#show port-security interface eth 0/1 address
VLAN Mac Address
--------------------------------------------------------------------------------------------------------------
1 00:a0:c8:0a:c6:4a
1 00:a0:c8:0a:c6:4b
--------------------------------------------------------------------------------------------------------------
Dynamic Address Count: 2
Static Address Count: 0
Sticky Address Count: 0
Total Address Count: 2
61200510L1-35E
Displays a list of secure medium access control (MAC) addresses for all
interfaces currently configured for port security.
Filters the output to include only information for a particular interface.
Displays the ports currently participating in port expiration and the amount of time
left until the port is shutdown.
Displays information for all interfaces, even if not configured for port expiration.
Command was introduced.
Type of Entry Interface
Dynamic-Secure eth 0/1
Dynamic-Secure eth 0/1
Copyright © 2005 ADTRAN
Enable Mode Command Set
Remaining Time
--
--
266