Table of Contents
Advertisement
Command Reference Guide
E1 I
NTERFACE
To activate the E1 Interface Configuration mode, enter the interface e1 command (and specify the E1
port) at the Global Configuration mode prompt. For example:
>enable
#configure terminal
(config)#interface e1 1/1
(config-e1 1/1)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
alias <"text">
on page 27
cross-connect <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port>
on page 28
description <text>
do
on page 32
end
on page 33
exit
on page 34
shutdown
on page 35
All other commands for this command set are described in this section in alphabetical order.
clock source [internal | line | through]
coding [ami | hdb3]
framing [crc4]
on page 599
loop-alarm-detect
on page 600
loopback network [line | payload]
loopback remote v54
remote-alarm [rai | ais]
remote-loopback
on page 604
sa4tx-bit [0 | 1]
on page 605
show test-pattern
on page 606
snmp trap line-status
snmp trap link-status
snmp trap threshold-reached
tdm-group <group number> timeslots <1-31> speed [56 | 64]
test-pattern [clear | insert | ones| p215 | p220 | p511 | qrss | zeros]
ts16
on page 612
61200510L1-35E
C
ONFIGURATION
on page 31
on page 597
on page 598
on page 601
on page 602
on page 603
on page 607
on page 608
on page 609
Copyright © 2005 ADTRAN
E1 Interface Configuration Command Set
C
S
OMMAND
ET
on page 610
on page 611
596
Hide quick links:
Advertisement
Chapters
Table of Contents
