Table of Contents
Advertisement
Command Reference Guide
DSX-1 I
NTERFACE
To activate the DSX-1 Interface Configuration mode, enter the interface t1 command (and specify the
DSX-1 port) at the Global Configuration mode prompt. For example:
>enable
#configure terminal
(config)#interface t1 1/2
(config-t1 1/2)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
alias <"text">
on page 27
cross-connect <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port>
on page 28
description <text>
do
on page 32
end
on page 33
exit
on page 34
shutdown
on page 35
All other commands for this command set are described in this section in alphabetical order.
coding [ami | b8zs]
framing [d4 | esf]
on page 588
line-length <value>
loopback network [line | payload]
loopback remote line [inband]
remote-loopback
on page 592
signaling-mode [message-oriented | none | robbed-bit]
snmp trap link-status
test-pattern [ones | zeros]
61200510L1-35E
C
ONFIGURATION
on page 31
on page 587
on page 589
on page 590
on page 591
on page 594
on page 595
Copyright © 2005 ADTRAN
DSX-1 Interface Configuration Command Set
C
S
OMMAND
ET
on page 593
586
Hide quick links:
Advertisement
Chapters
Table of Contents
