ADTRAN 1000R Series Command Reference Manual page 254

Command Reference Guide
show mac address-table dynamic
Use the show mac address-table dynamic command to display all dynamic medium access control
(MAC) addresses learned by the AOS.
Variations of this command include the following:
show mac address-table dynamic
show mac address-table dynamic address <mac address>
show mac address-table dynamic address <mac address> interface <interface type> <interface id>
show mac address-table dynamic address <mac address> interface <interface type> <interface id>
vlan <vlan id>
show mac address-table dynamic address <mac address> vlan <vlan id>
show mac address-table dynamic interface <interface type> <interface id>
show mac address-table dynamic interface <interface type> <interface id> vlan <vlan id>
show mac address-table dynamic vlan <vlan id>
Syntax Description
address <mac address>
interface <interface type> Shows information for a specific interface. Type show mac address-table
<interface id>
vlan <vlan id>
Default Values
No default value necessary for this command.
Applicable Platforms
This command applies to the NetVanta 300, 1000, 1000R, and 2000 Series units.
Command History
Release 5.1
61200510L1-35E
Specifies a valid 48-bit MAC address.
dynamic interface ? for a list of valid interfaces.
Specifies a valid slot/port interface ID (e.g., 0/1).
Specifies a valid VLAN interface ID (1 to 4094).
Command was introduced.
Copyright © 2005 ADTRAN
Enable Mode Command Set
254