Command Reference Guide
Enable Mode Command Set
show mac address-table aging-time
Use the show mac address-table aging-time command to display information regarding the amount of
time dynamic entries remain in the medium access control (MAC) address table.
Syntax Description
No subcommands.
Default Values
No default value necessary for this command.
Applicable Platforms
This command applies to the NetVanta 300, 1000, 1000R, and 2000 Series units.
Command History
Release 5.1
Command was introduced.
Usage Examples
The following is a sample from the show mac address-table aging-time command for a switch
configured with an address-table aging-time:
>enable
#show mac address-table aging-time
Aging Time
----------------
300
Seconds
61200510L1-35E
Copyright © 2005 ADTRAN
252