ADTRAN 1000R Series Command Reference Manual page 696

Command Reference Guide
test-pattern [clear | insert | 2^15 | show]
Use the test-pattern command to activate the built-in pattern generator and begin sending the selected test
pattern toward the network. This pattern generation can be used to verify a data path when used in
conjunction with an active loopback. Use the no form of this command to cease pattern generation.
Syntax Description
clear
insert
2^15
show
Default Values
No defaults necessary for this command.
Applicable Platforms
This command applies to the NetVanta 1000R, 3000, and 4000 Series units.
Command History
Release 3.1
Usage Examples
The following example sends a 2
(config)#interface shdsl 1/1
(config-shdsl 1/1)#test-pattern 2^15
61200510L1-35E
Clears the test pattern error count.
Inserts an error into the currently active test pattern.
Generates a pseudorandom test pattern sequence based on a 15-bit shift register.
Displays the injected error result.
Command was introduced.
15
test pattern:
Copyright © 2005 ADTRAN
SHDSL Interface Configuration Command Set
696