ADTRAN 1000R Series Command Reference Manual page 948

Command Reference Guide
dial-backup redial-delay <seconds>
Use the dial-backup redial-delay command to configure the delay after an unsuccessful call until the call
will be re-tried. For more detailed information on PPP dial-backup functionality, refer to the Functional
Notes and Technology Review sections of the command dial-backup call-mode [answer | answer-always |
originate | originate-answer | originate-answer-always]
Syntax Description
<seconds>
Default Values
By default, dial-backup redial-delay is set to 10 seconds.
Applicable Platforms
This command applies to the NetVanta 1000R, 3000, 4000, and 5000 Series units.
Command History
Release 1.1
Release 5.1
Usage Examples
The following example configures a redial delay of 25 seconds on this endpoint:
(config)#interface ppp 1
(config-ppp 1)#dial-backup redial-delay 25
61200510L1-35E
Specifies the delay in seconds between attempting to re-dial a failed backup
attempt. Range: 10 to 3600.
Command was introduced.
Command was expanded to include the PPP interface.
Copyright © 2005 ADTRAN
on page 939.
HDLC Command Set
948