ADTRAN 1000R Series Command Reference Manual page 718

Command Reference Guide
access-policy <policyname>
Use the access-policy command to assign a specified access policy for the inbound traffic on an interface.
Use the no form of this command to remove an access policy association.
Configured access policies will only be active if the ip firewall command has been entered
at the Global Configuration mode prompt to enable the AOS security features. All
configuration parameters are valid, but no security data processing will be attempted
unless the security features are enabled.
Syntax Description
<policyname>
Default Values
By default, there are no configured access policies associated with an interface.
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 3000, and 4000 Series units.
Command History
Release 2.1
Release 6.1
Release 8.1
Functional Notes
To assign an access policy to an interface, enter the interface configuration mode for the desired interface
and enter access policy <policy name>.
Usage Examples
The following example associates the access policy UnTrusted (to allow inbound traffic to the Web server)
to the ATM sub-interface labeled 1.1:
Enable the AOS security features:
(config)#ip firewall
Create the access list (this is the packet selector):
(config)#ip access-list extended InWeb
(config-ext-nacl)#permit tcp any host 63.12.5.253 eq 80
61200510L1-35E
Identifies the configured access policy by alphanumeric descriptor (all access
policy descriptors are case-sensitive).
Command was introduced.
Command was expanded to 1000 and 2000 Series units.
ATM sub-interface was added.
Copyright © 2005 ADTRAN
ATM Sub-Interface Config Command Set
718